H3C Technologies H3C S10500 Series Switches - Manual (Page 286)

271
To do... Use the command... Remarks
Configure the source IPv6 address
of MLD general queries
mld-snooping general-query
source-ip { ipv6-address |
current-interface } Required
FE80::02FF:FFFF:FE00:0001 by
default.
Configure the source IPv6 address
of MLD multicast-address-specific
queries
mld-snooping special-query
source-ip { ipv6-address |
current-interface }
Required
FE80::02FF:FFFF:FE00:0001 by
default.
CAUTION:
The source IPv6 address of MLD query messages might affect MLD querier election within the segment.
Configuring MLD snooping proxying
Configuration prerequisites
Before you configure MLD snooping proxying in a VLAN, complete the following tasks:
• Enable MLD snooping in the VLAN
• Determine the source IPv6 address for the MLD reports sent by the proxy
• Determine the source IPv6 address for the MLD done messages sent by the proxy
Enabling MLD snooping proxying
The MLD snooping proxying function works on a per-VLAN basis. After you enable the function in a
VLAN, the device works as the MLD snooping proxy for the downstream hosts and upstream router in the
VLAN.
Follow these steps to enable MLD snooping proxying in a VLAN:
To do... Use the command... Remarks
Enter system view system-view —
Enter VLAN view vlan vlan-id —
Enable MLD snooping proxying
in the VLAN
mld-snooping proxying enable
Required
Disabled by default.
Configuring a source IPv6 address for the MLD messages sent
by the proxy
You can set the source IPv6 addresses in the MLD reports and done messages that the MLD snooping
proxy sends on behalf of its attached hosts.
Follow these steps to configure the source IPv6 addresses for the MLD messages that the MLD snooping
proxy sends on behalf of its attached hosts in a VLAN:
To do... Use the command... Remarks
Enter system view system-view —