H3C Technologies H3C S10500 Series Switches User Manual

Page 327

312

[RouterA] interface gigabitethernet 1/0/1

[RouterA-GigabitEthernet1/0/1] pim ipv6 dm

[RouterA-GigabitEthernet1/0/1] quit

[RouterA] interface gigabitethernet 1/0/2

[RouterA-GigabitEthernet1/0/2] pim ipv6 dm

[RouterA-GigabitEthernet1/0/2] mld enable

Configure Switch A

# Enable MLD snooping globally.

system-view

[SwitchA] mld-snooping

[SwitchA-mld-snooping] quit

# Create VLAN 2 through VLAN 5.

[SwitchA] vlan 2 to 5

# Configure GigabitEthernet 1/0/2 as a trunk port that permits packets from VLAN 2 and VLAN 3 to

pass through.

[SwitchA] interface gigabitethernet 1/0/2

[SwitchA-GigabitEthernet1/0/2] port link-type trunk

[SwitchA-GigabitEthernet1/0/2] port trunk permit vlan 2 3

[SwitchA-GigabitEthernet1/0/2] quit

# Configure GigabitEthernet 1/0/3 as a trunk port that permits packets from VLAN 4 and VLAN 5 to
pass through.

[SwitchA] interface gigabitethernet 1/0/3

[SwitchA-GigabitEthernet1/0/3] port link-type trunk

[SwitchA-GigabitEthernet1/0/3] port trunk permit vlan 4 5

[SwitchA-GigabitEthernet1/0/3] quit

# Create VLAN 10, assign GigabitEthernet 1/0/1 to this VLAN and enable MLD snooping in the VLAN.

[SwitchA] vlan 10

[SwitchA-vlan10] port gigabitethernet 1/0/1

[SwitchA-vlan10] mld-snooping enable

[SwitchA-vlan10] quit

# Configure VLAN 10 as an IPv6 multicast VLAN and configure VLAN 2 through VLAN 5 as its
sub-VLANs.

[SwitchA] multicast-vlan ipv6 10

[SwitchA-ipv6-mvlan-10] subvlan 2 to 5

[SwitchA-ipv6-mvlan-10] quit

Configure Switch B

# Enable MLD snooping globally.

system-view

[SwitchB] mld-snooping

[SwitchB-mld-snooping] quit

# Create VLAN 2, assign GigabitEthernet 1/0/2 to VLAN 2, and enable MLD snooping in the VLAN.

[SwitchB] vlan 2

[SwitchB-vlan2] port gigabitethernet 1/0/2

[SwitchB-vlan2] mld-snooping enable

[SwitchB-vlan2] quit

This manual is related to the following products: