H3C Technologies H3C S10500 Series Switches - Manual (Page 389)

374
To do... Use the command... Remarks
Configure the hop limit value of
state-refresh messages state-refresh-hoplimit
hoplimit-value Optional
255 by default
Configuring IPv6 PIM-DM graft retry period
In IPv6 PIM-DM, graft is the only type of message that uses the acknowledgment mechanism. In an IPv6
PIM-DM domain, if a router does not receive a graft-ack message from the upstream router within the
specified time after it sends a graft message, the router keeps sending new graft messages at a
configurable interval—namely, graft retry period—until it receives a graft-ack message from the
upstream router.
Follow these steps to configure the IPv6 PIM-DM graft retry period:
To do... Use the command... Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Configure the graft retry period pim ipv6 timer graft-retry interval
Optional
3 seconds by default
NOTE:
For more information about the configuration of other timers in IPv6 PIM-DM, see “ Configuring IPv6 PIM
common timers .”
Configuring IPv6 PIM-SM
IPv6 PIM-SM configuration task list
Complete these tasks to configure IPv6 PIM-SM:
Task Remarks
Enabling IPv6 PIM-SM Required
Configuring a static RP
Configuring a C-RP
Enabling embedded RP
Required
Use any approach
Configuring an RP
Configuring C-RP timers globally Optional
Configuring a C-BSR Required
Configuring an IPv6 PIM domain border Optional
Configuring C-BSR parameters globally Optional
Configuring C-BSR timers Optional
Configuring a BSR
Disabling BSM semantic fragmentation Optional
Configuring IPv6 Enabling IPv6 administrative scoping Optional