Configuration procedure – H3C Technologies H3C S10500 Series Switches User Manual
Page 238
223
Figure 63 Network diagram for inter-AS multicast configuration by leveraging static RPF peers
Vlan-int103
Vla
n-i
nt1
04
Switch B
Switch A
Source 1
AS 100
PIM-SM 1
PIM-SM 3
PIM-SM 2
Loop0
Switch D
Switch E
Switch F
Switch G
Source 2
Vlan-int102
Vl
an-
int101
Vlan-int103
Vlan-int105
Vlan-int106
Loop0
Receiver
Receiver
Loop0
BGP peers
Vl
an-
int10
1
Vlan-int105
Vlan-int106
Vlan-
in
t30
0
Vl
an
-int4
00
AS 200
Vla
n-i
nt1
04
Vlan-int102
Vl
an
-int200
Vlan-int100
Switch C
Device Interface IP
address
Device Interface IP
address
Source 1
-
192.168.1.100/24
Switch D
Vlan-int105
10.110.5.1/24
Source 2
-
192.168.3.100/24
Vlan-int103
10.110.3.2/24
Switch A
Vlan-int101
10.110.1.1/24
Loop0
2.2.2.2/32
Vlan-int102 10.110.2.1/24
Switch
E Vlan-int105 10.110.5.2/24
Loop0
1.1.1.1/32
Vlan-int300
192.168.3.1/24
Switch B
Vlan-int101
10.110.1.2/24
Switch F
Vlan-int106
10.110.6.1/24
Vlan-int100 192.168.1.1/24
Vlan-int104 10.110.4.2/24
Vlan-int103 10.110.3.1/24
Switch
G Vlan-int106 10.110.6.2/24
Switch
C Vlan-int102 10.110.2.2/24
Vlan-int400 192.168.4.1/24
Vlan-int200
192.168.2.1/24
Loop0
3.3.3.3/32
Vlan-int104
10.110.4.1/24
Configuration procedure
1.
Configure IP addresses and unicast routing
Configure the IP address and subnet mask for each interface as per
. (details not shown)
Configure OSPF for interconnection between the switches. Ensure the network-layer interoperation in
each AS, and ensure the dynamic update of routing information among the switches through a unicast
routing protocol. (details not shown)
2.
Enable IP multicast routing, enable PIM-SM and IGMP, and configure a PIM-SM domain border
# Enable IP multicast routing on Switch C, enable PIM-SM on each interface, and enable IGMP on the
host-side interface VLAN-interface 200.
[SwitchC] multicast routing-enable
[SwitchC] interface vlan-interface 102
[SwitchC-Vlan-interface102] pim sm