H3C Technologies H3C S10500 Series Switches - Manual (Page 221)

206
H3C recommends you to establish MSDP peering relationships between RP 1 and RP 3 and between RP
3 and RP 2, respectively.
Figure 59 Inter-domain multicast delivery through MSDP
RP 1
DR 1
Source
PIM-SM 1
PIM-SM 3
PIM-SM 2
PIM-SM 4
RP 3
RP 2
DR 2
MSDP peers
SA message
Join message
Multicast packets
Register message
Receiver
The process of implementing PIM-SM inter-domain multicast delivery by leveraging MSDP peers is as
follows:
1. When the multicast source in PIM-SM 1 sends the first multicast packet to multicast group G, DR 1
encapsulates the multicast data within a register message and sends the register message to RP 1.
Then, RP 1 identifies the information related to the multicast source.
2. As the source-side RP, RP 1 creates SA messages and periodically sends the SA messages to its
MSDP peer. An SA message contains the source address (S), the multicast group address (G), and
the address of the RP that has created this SA message (namely, RP 1).
3. On MSDP peers, each SA message undergoes a reverse path forwarding (RPF) check and
multicast policy–based filtering, so that only SA messages that have arrived along the correct path
and passed the filtering are received and forwarded. This avoids delivery loops of SA messages.
In addition, you can configure MSDP peers into an MSDP mesh group so as to avoid flooding of
SA messages between MSDP peers.
4. SA messages are forwarded from one MSDP peer to another, and finally the information about the
multicast source traverses all PIM-SM domains with MSDP peers (PIM-SM 2 and PIM-SM 3, in this
example).
5. After receiving the SA message that RP 1 created, RP 2 in PIM-SM 2 determines whether any
receivers for the multicast group exist in the domain.
○ If receivers for the multicast group exist in the domain, the RPT for the multicast group G is
maintained between RP 2 and the receivers. RP 2 creates an (S, G) entry and sends an (S, G)
join message hop by hop toward DR 1 at the multicast source side, so that it can directly join the
SPT rooted at the source over other PIM-SM domains. Then, the multicast data can flow along
the SPT to RP 2 and RP 2 can forward the data to the receivers along the RPT. After receiving the
multicast traffic, the DR at the receiver side (DR 2) determines whether to initiate an RPT-to-SPT
switchover process.