Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 94)

3-66 W A N s u i t e 6 4 5 0
The Static UDP Translation Table screen provides the following user-
activated buttons:
You can configure or change the above-listed parameters on the NAT Static
UDP Translation Details screen (Figure 3.60), which is accessed by selecting
the appropriate number under the Index column on the Static UDP Translation
Table screen.
Figure 3.60 NAT Static UDP Translation Details Screen
NAT Port Table Screen
The parameters on the NAT Port Table screen (Figure 3.61) define the NAT
global/Internet and local/Corporate ports. These parameters are configured in
the NAT Ports Details screen shown in Figure 3.62. Access the NAT Port
Details screen by clicking on the Index number of the desired port on the
NAT Port Table screen.
Figure 3.61 NAT Port Table Screen
Endpoint The Endpoint name of the circuit associated with the LAN or WAN port.
Default is LAN for the first port.
Enable Enables or disables the NAT port. Default is “Enable.”
Default Translation Forces translation on a specific IP port regardless of the source IP Address. If
Default Translation is set to “Enable,” the packet will never be discarded, but
will always pass through the translation path. Therefore, any packets with a
destination address different from the global/Internet network address will be
Button Function
NAT Details Returns the user to the previous screen.
Add New Lets the user add an additional address.