Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 78)

3-50 W A N s u i t e 6 4 5 0
Figure 3.42 Circuit Table Screen
Circuit Details Screen
Clicking on the “Circuit Details” button on the Circuits screen will display a
screen similar to the following (Figure 3.43). This screen is used to establish the
configuration parameters of a given circuit. To establish a new circuit or to
change the parameters of an existing circuit, enter the desired values in the
available parameter fields and press the “Submit” button.
NOTICE: A “Submit” on this screen will activate a newly created circuit. It is not
necessary to perform a “Save and Restart” for the circuit to take effect.
Figure 3.43 Circuit Details Screen
Endpoint Endpoint name. By default, the first circuit is always the LAN circuit. WAN
circuit endpoint names are taken from the VPI/VCI number. For example,
VPI 0/VCI 32 will have “P0-C32” for an endpoint name. The pull-down
menu will display a list of VPI/VCIs actually configured. A given circuit will
receive/transmit data on the VPI/VCI combination corresponding to its
endpoint name.
IP Address IP Address of the circuit.