Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 79)

W e b S e r v e r I n t e r f a c e 3-51
IP Mask IP Mask of the circuit.
Max Transmit Unit Maximum transmit unit this circuit will send at any one time.
Cost Represents the relative time of treatment of an IP packet. This value is used
when there are multiple routes to the same destination. When two or more
routes are available, the one with the lowest circuit cost is selected. An ATM
circuit should have a higher value than a LAN circuit.
RIP Status Indicates whether or not RIP is enabled on this circuit.
Values: Disable, Listen and Talk, Talk Only, Listen Only
Default: Listen and Talk
Multicast Status Indicates whether or not Multicast is enabled on this circuit.
Values: Enable, Disable
Default: Enable
OSPF Status Indicates whether or not OSPF is enabled on this circuit.
Values: Enable, Disable
Default: Disable
OSPF Area Represents the area that this circuit is part of.
OSPF LSA Timer Determines how often the Link State Acknowledgment (LSA) packet is sent.
Values: 1
−
3600
Default: 5
OSPF LSU Delay The estimated number of seconds it takes to transmit a Link State Update
(LSU) packet over this circuit interface.
Values: 1
−
3600
Default: 1
OSPF Router Priority This 8-bit unsigned integer ranges from 1 to 255 and assigns priority to one of
two routers attached to the same network; without an assigned priority, both
routers attempt to become the designated router.
Values: 1
−
255
Default: 1
OSPF Hello Interval The time in seconds between the Hello packets that a router sends on a
circuit. This value is also advertised in the router’s Hello packets and must be
identical for all routers on the same network. The smaller the Hello Interval,
the sooner topological changes are detected (but then more traffic is created).
Values: 1
−
65535
Default: 10