Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 107)

W e b S e r v e r I n t e r f a c e 3-79
The table below shows the possible file operations.
Note that when updating the application software using a .HEX file, the
filename should have the form xxAPxxxx.HEX; the AP indicates the file is
an application load. When updating the boot software, the filename should
have the form
xxWBxxxx.HEX ; the WB indicates the file is a boot load.
Password
The Password Details screen (Figure 3.78) is used to modify the password
that restricts access to the Web Server interface.
Acceptable characters for use in a password are digits 0–9 and letters A–Z
and a–z, for a total of 62 distinct characters.
Figure 3.78 Password Details Screen
To change either the Admin or Read-Only password, you must enter it once
in the New Password field and then re-enter the same password in the
Confirm Password field. After entering the new password in both these fields,
click the “Change Admin Password” or the “Change Read Only Password”
button to update and establish the new password.
NOTICE: Remember that passwords are case-sensitive. When logging on,
password must be entered exactly as it was programmed.
Log Out
The Log Out screen (Figure 3.79) is used to log the current user off of the
Web Server.
Operation Filename Extension Action
Update Application Firmware .CHX or .HEX(1) Get
Update Boot Firmware .HEX(2) Get
Save Configuration Setup .CFG Put
Restore Configuration Setup .CFG Get