Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 192)

A-2 W A N s u i t e 6 4 5 0
T1
Line Rate: 1.544 Mbps (
±
50 bps)
Line Framing: SF, ESF, or 1.544 Mbits unframed
Line Code: AMI or B8ZS
Receiver Sensitivity: 30 dB of cable loss
Connection: RJ-48 jack at 100
Ω
(
±10 %)
Output Signal: 3.0 V (
±
10 %) base -peak into 100
Ω
Mode: Short- or long-haul
Jitter Control: per Bellcore Document TA-TSY-000170
Number of DS0s Selectable: From 1 to full T1 (noncontiguous)
Serial Interface
Connection: DB-25 female
DTE Ports: Selectable V.35, V.36, X.21, RS-232, RS-449, or EIA-530
DTE/DCE: Selectable (matching cable required)
Data Rate: Synchronous, nx 64 kbps (where n = 1
−
36)
Clocking: Internal, External
Supports RFC 1483, Synchronous PPP, CES via AAL 1
IP Gateway
10/100 Ethernet (IP Gateway or Management)
Protocols: RIP1, RIP2, OSPF
Connection: 8-pin modular
Network Protocol: TCP /IP based networks
Data Rate: 10/100 Mbps
Compatibility: 10/100Base-T
Management Interfaces
Embedded Operations Channel
Embedded messaging to enable management of the SHDSL-related parameters.
10/100 Ethernet
Connection: 8-pin modular
Network Protocol: TCP /IP based networks
Data Rate: 10/100 Mbps
Compatibility: 10/100Base-T
Supervisory Port
Connection: DB-9 female