Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 77)

W e b S e r v e r I n t e r f a c e 3-49
RIP Parameters
RIP Enable Globally enables RIP 1, RIP 2, or No RIP.
Values: Disable, Enable RIP1, Enable RIP2
Default: Enable (RIP2)
RIP Trust Neighbors Globally enables the trusted neighbors feature. If there is a list of trusted
neighbors in an IP Gateway, only RIP packets coming from those trusted
neighbors will be used to build the internal routing table.
Values: Enable, Disable
Default: Enable
RIP Interval Interval for RIP packet to be sent. Default is 30 seconds.
RIP Domain Value representing the RIP domain. Default is 0.
OSPF Parameters
OSPF Enable This Protocol is suitable for complex networks with a large number of routers.
If a large network is involved, OSPF may be the solution for the user.
Values: Disable, Enable
Default: Disable
OSPF Router ID This 32-bit number assigned to each router running the OSPF protocol
uniquely identifies the router within an autonomous system. Each router
requires a unique router ID. Default is the LAN IP Address of the unit.
The IP Gateway screen provides the following user-activated buttons:
Circuit Table Screen
Access this menu by clicking on the “Circuit Table” button at the bottom of the
IP Gateway menu. This screen shows the configured circuit. To configure a new
circuit, click on "Add New."
Button Function
RIP Parameters
Static Routes Table Displays static routes and dynamic routes information.
Static ARP Table Displays static ARP information.
Trusted Neighbors Displays trusted neighbors information.
OSPF Parameters
Area Table Displays area information.
Virtual Link Table Displays virtual link information.
Submit Submits to the unit information specific to IP Gateway.
Circuit Table Lets you access to circuit-related information/operation.