Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 53)

W e b S e r v e r I n t e r f a c e 3-25
Stop Bit Selects the number of bits required to end the character.
Values: 1, 2
Default: 1
Current Pin Status The Current Pin Status, which shows the state of the RS-232 pins, is also
displayed on the Supervisory interface screen.
Services
The Services screen (Figure 3.23) provides a view of the unit’s defined
services and displays the Interface and Type parameters for each service.
Figure 3.23 Services Screen
The table in the center of the screen displays the available services listed by
index number.
Service Details Screen
Clicking on an index number under the Service Index column will display a
Service Details screen such as the one shown below (Figure 3.24). (In this
example, the selected service type is CES.)
Figure 3.24 Service Details Screen
From this screen, you can access and change the parameters listed below. The
new parameters are saved when you click on “Submit” and return to the
previous screen.