Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 35)

W e b S e r v e r I n t e r f a c e 3-7
Pair-2 Mode Represents the status and detail status information of the span for four-wire
operation. This mode is not supported by the WANsuite 6450.
EOC In Displays the number of messages received on the Embedded Operations
Channel.
EOC Out Displays the number of messages transmitted on the Embedded Operations
Channel.
Discovered Repeaters Displays the number of discovered repeaters in this span.
Line Rate Displays the actual negotiated line rate.
Maximum Line Rate Displays the maximum physical line rate.
Transmission Mode Displays the actual transmission mode (Annex-A or Annex-B).
The Network screen provides the user-activated buttons described below.
CAUTION: Performance data will be lost upon power cycle or after performing a
Maintenance Reset/Restart.
Configuration Profile Table Screen
Clicking on the “Configuration Profiles” button on the Network screen will
display the table shown in Figure 3.5.
Figure 3.5 Configuration Profile Table Screen
This table displays the information the user specifies in the Configuration
Profile Details screen (Figure 3.6), which is accessed by clicking on the
specific Profile Name hyperlink in the table above.
Button Function
Submit Sets any values that have been changed.
Configuration Profiles Displays the three configuration profiles that can be used.
Alarm Profiles Displays the four alarm profiles that can be used.
Span Endpoints Lists the currently available span endpoints.