Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 71)

W e b S e r v e r I n t e r f a c e 3-43
Figure 3.35 Rule Details Screen
The paragraphs below describe the rule configuration parameters and their
options.
Service Selects the service to which the rule applies. Select from a pull-down menu
that lists available services.
VPI Selects the VPI to which the rule applies.
VCI Selects the VCI to which the rule applies.
Filter By VPI/VCI Enables or disables filtering of the IP traffic in accordance with the specified
VPI/VCI.
NOTICE: To use this filter, you must specify both the Service and VPI/VCI
parameters in the Rule Config screen.
IP Address Establishes the IP Address by which the rule will filter IP traffic (if enabled).
IP Mask Represents a range of IP Addresses defined so that only machines with IP
Addresses within the range defined by the mask are allowed to access an
Internet service. To mask a portion of the IP Address, replace it with the wild
card character “0” (zero). (For example, 192.44.0.0 represents every computer
on the Internet with an IP Address beginning with 192.44.)
Filter By IP Address Enables or disables filtering of the IP traffic by the IP Address specified in
the IP Address or IP Mask field.
IP Port Establishes the IP port by which the rule will filter IP traffic (if enabled).
Filter By IP Port Enables or disables filtering of the IP traffic by the IP port specified in the IP
Port field.