Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 134)

4-26 W A N s u i t e 6 4 5 0
Cur. Pin Status Shows the status of the DTE Serial port pins.
10/100 Ethernet (IP Details)
If you select “10/100Ethernet” from the Interfaces screen, you will bring up
an IP Details screen (Figure 4.22) that lets you view and/or modify the IP
parameters listed below.
Figure 4.22 IP Details Screen
IP Address A unique network address assigned to this unit.
Subnet Mask Defines the network portion of the unit’s IP Address.
Gateway IP Address IP Address of the default gateway (router) on the LAN side of the unit.
DHCP Client If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and
Gateway addresses from a DHCP server located on the LAN side of the unit,
and the unit will use these addresses. If the DHCP request is unsuccessful, the
unit will use the configured addresses shown on this screen.
Client Identifier Displays a unique identifier for a specific IP address.
NOTICE: Always verify that a DHCP server is available on the network before
enabling DHCP Client. If, on power-up, a DHCP server is not found, a
60-second timeout will occur.
Ethernet Enables or disables a remote unit’s Ethernet port.
Physical Address Displays unique MAC address.
NOTICE: If you manually change the IP Address, you must “Save and Restart.”
(See "Save and Restart" on page 4-6.)