Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 202)

B-2 W A N s u i t e 6 4 5 0
• rfc2013.mib
−
for managing UDP implementations
• rfc2096.mib
−
for the display of CIDR multipath IP routes
•
rfc2493.mib
−
provides textual conventions to be used by systems
supporting 15-minute based performance history counts
• rfc2514.mib
−
ATM Management MIB
• rfc2515.mib
−
ATM Management MIB
• rfc2571.mib
−
the SNMP Management Architecture MIB
• rfc2863.mib
−
describes generic objects for network interface sub-layers
(This MIB is an updated version of MIB-II's ifTable, and
incorporates the extensions defined in RFC 1229.)
• rfc3276.mib
−
MIB module for SHDSL
The WANsuite 6450 supports the following Enterprise-specific MIBs:
•
ds8200tc.mib
−
textual conventions used by DS8200 MIB
•
ds8200v2.mib
−
provides T1 configuration and statistics information
•
ipadatm.mib
−
proprietary extensions to ATM Management MIBs
• ipadv2.mib
−
provides Frame Relay, PPP, and Service Aware
configuration and statistics
• ipstart.mib
−
MIB module for synchronous PPP
• router.mib
−
provides configuration of OSPF router
These MIB files may be found on the Verilink Documentation CD included
with the unit.
SNMP Trap Configuration
The WANsuite 6450 supports up to eight IP destinations for SNMP traps.
These may be configured either through the Web interface or through an
SNMP management application. For configuration of these destinations
through an SNMP management application, use a MIB browser to access the
table
trapdest within ipadv2.mib and set the IP Addresses of the host
computer running the management application(s). Entering an IP Address of
0.0.0.0 will disable the entry.
Generic MIB Loading Instructions
The MIBs were written using the standard ASN.1 notation. Any standard SNMP
manager should be able to compile the MIBs. Although the exact procedure for
loading MIBs may vary from one platform to another, the following basic steps
are the same.
1 The SNMP manager has a directory for MIBs. Copy the files
ds8200tc.mib , ds8200v2.mib , ipadv2.mib , ipstart.mib ,
router.mib , and ipadatm.mib into this directory. The MIBs use a
DOS format; therefore, a DOS2UNIX command may have to be used for
UNIX workstations (typical directories are
snmp_mibs for HP’s