Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 123)

V T 1 0 0 I n t e r f a c e 4-15
Figure 4.14 Span Endpoint Maintenance Screen
The Span Endpoint Maintenance parameters are described below.
Loopback Type Specifies loopbacks for the associated segment endpoint.
Values: No Loopback, Normal Loopback
Default: No Loopback
Loopback Timeout Specifies the timeout value in minutes for loopbacks initiated at this endpoint.
A value of 0 disables the timeout.
Tip Ring Indicates the state of the tip/ring pair at the associated segment endpoint.
Power Source Indicates the DC power source being used by the associated unit.
Restart Endpoint Enables the manager to trigger a soft restart of the SHDSL line at the
associated segment endpoint. Set this object to “restart” to initiate a restart. A
restart will occur after approximately 5 seconds.
Values: Ready, Restart
Default: Ready
Selecting the “Performance” prompt on the Span Endpoint Details screen will
display the screen shown in Figure 4.15.