Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 70)

3-42 W A N s u i t e 6 4 5 0
established through the Rule Config screen, which is accessed by clicking the
“Rule Details” button at the bottom of the Service Aware screen.
The Service Aware screen (Figure 3.34) provides a table showing these
filtered packet counts for up to 10 rules. This table indicates which Service
Aware filters are enabled or disabled, and shows the specific VPI/VCI, IP
Address, and IP Port by which the IP traffic is filtered. In addition, this table
shows the Tx Alarm Threshold and the current Tx Alarm status (if enabled)
for each rule.
Figure 3.34 Service Aware Screen
The Service Aware screen provides a “Clear Alarms” user-activated buttons:
Rule Details Screen
Access the Rule Details screen (Figure 3.35), where you can establish Service
Aware parameters, by selecting the appropriate hyperlink from the “Index”
column in the above screen. To establish a rule, select the desired rule
configuration options, provide the appropriate filter information where
required, and click on the “Submit” button at the bottom of the screen.