Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 162)

4-54 W A N s u i t e 6 4 5 0
Endpoint Endpoint name (or interface) through which to send the IP packet to reach the
Target IP Address.
Target IP Address Represents the target network that you want this router to reach.
Values: 0.0.0.0
−
255.255.255.255
Default: 0.0.0.0
Target IP Mask Mask of the Target IP or network.
Represents the target network that you want this router to reach.
Values: 0.0.0.0
−
255.255.255.255
Default: 0.0.0.0
NOTICE: Setting the Target IP Address and Target IP Mask to 0.0.0.0. defines
THE default route for this unit.
Next Hop IP Address: IP Address of the next device in the route.
Cost Cost of using that route.
Values: 0
−
65535
Default: 1
Route Status Indicates whether or not the current route is enabled.
Values: Disable, Enable, Enable and Advertise
Default: Enable
Dynamic Route Table Screen
Access this menu (Figure 4.46) by selecting the “Static Route Table” on the
IP Gateway menu and then selecting Dynamic Route Table. This table shows
both dynamic and circuit tables. Please note that not all parameters are
necessarily defined, depending on whether or not the routes were learned
dynamically. Primarily, the most useful information is included in
"Destination," "If Ndx," and "Mask" columns.