Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 19)

A b o u t t h e W A N s u i t e 6 4 5 0 1-5
• Full or partial T1/E1 circuits with signaling
• Unstructured service (2.048 Mbps E1 or 1.544 Mbps T1)
• Configurable for synchronous or adaptive timing
• User configurable Cell Delay Variation
• User configurable partial cell fill
• User configurable scrambling/descrambling of ATM cell Payload using an
x
43
+1 polynomial
• User configurable time slot multiplexing between the CBR port and the
Serial port
• For Nx64 basic and CAS services, the user can individually configure
the CES channels for the CBR port or for the Serial port
• For Unstructured E1 service, the user can configure all channels for
either the CBR port of for the Serial port
• IP Gateway
• 10/100Base-T Ethernet port
• Static routes
• Static Address Resolution Protocol (ARP)
• Dynamic routing protocols, including RIP 1, RIP 2, and OSPF
• Un-numbered network
• Address Management: NAT and DHCP
• Bridging
• Programmable alarm thresholds
• IPoA
•
Serial Port Configurable for PPP or CES
• Supports V.35, V.36, EIA-530, or RS-232
• PPPoA
• Management Interfaces
• WANsight
−
an innovative Web-based user interface
• Embedded HTTP server for remote configuration and real-time
reporting via Web browser
• Decreased installation and configuration time for service employees
• Simplified troubleshooting and fault isolation of network problems
• Optimal management of ATM-based services
• Saves and downloads configuration files from remote server
• EOC for SHDSL-related parameters
• SNMP
• VT100