Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 183)

V T 1 0 0 I n t e r f a c e 4-75
System Up Time Displays the amount of time that the unit has been operational since it was
turned on or last reset.
The Top Talkers table reports in descending order the IP Addresses that have
generated the most traffic during the requested report’s duration. For each IP
Address listed, the report displays the number of Rx frames, Rx octets, Tx
frames, and Tx octets that have been passed across it. In addition, the
Timestamp field indicates the time at which a packet was examined for the
specified IP Address.
Originate Ping
The WANsuite 6450 Originate Ping (Figure 4.68) function helps telephone
companies determine if a network is properly configured and also helps them
maintain SLAs.
Figure 4.68 Originate Ping Screen
The parameters on the left side of the screen offer you the following choices:
Start Ping, Stop Ping, or Reset the Status (clears all counts activity). Other
parameters include the following:
Dest IP Address Destination IP Address of sent Ping request messages.
Number to Send Number of Ping request messages to send.
Values: 1
−
10,000
Default: 5
Ping Size Number of bytes in a Ping request message.
Values: 4
−
4096 bytes
Default: 64 bytes
Ping Reply Timeout Number of seconds to wait for a reply to a Ping request message.
Values: 1
−
60 s
Default: 1 s