Measurement Computing WBK Options - Manual (Page 37)

WBK15, pg. 4 988396 WBK15, 5B Isolated Signal Conditioning Module
Power
Like the WaveBook, WBK15 contains an internal power supply. The unit can be powered by the included
AC power adapter or any 10 to 30 VDC source, such as a 12 V car battery. For portable or field
applications, WBK15 and the WaveBook can be powered by the DBK30A rechargeable battery module or
DBK34 vehicle UPS module. The supply input is fully isolated from the measurement system. If the fuse
requires replacement, it is a 2 A fuse (Littelfuse #251002).
Prior to daisy-chaining from one module’s power connector to another, be sure to
compute the power consumption for the entire system. Some modules may need
independent power adapters. The WaveBook manual’s chapter entitled,
System Setup
and Power Options contains detailed information regarding power supply issues.
Safety Concerns
WARNING WARNING WARNING WARNING
Shock Hazard! Voltages above 50 Vrms AC and voltages above 100 VDC are
considered hazardous. Safety precautions are required when 5B modules are used in
situations that require high-voltage isolation from the rest of the system. Failure to
practice electrical safety precautions could lead to injury or death.
WBK15 is specified for 1500 VDC isolation in a normal environment free from conductive pollutants and
condensation. The 1500 VDC rating requires a proper earth ground connection to the chassis and treatment
of adjacent inputs as potentially hazardous. CE-marked units used in the European community are rated at
600 VDC isolation. The 600 VDC CE isolation specification is based on a double insulation requirement,
and no earth ground is required.
Input cables must be rated for the isolation potential in use. Line voltage ratings are much lower than the
DC isolation values specified due to transients that occur on power lines. Never open the lid unless all
inputs with potentially hazardous voltages are removed. The lid must be securely screwed on during use.
Some things to remember:
• Before closing up an open WBK15, ensure no foreign objects are inside.
• Properly tighten all chassis screws before system use.
• Properly tighten the screw that retains the 5B module.
• Never plug in or unplug potentially hazardous connections with power applied to any
connected equipment.
• Never attempt to change 5B modules or open the lid with power applied to the WBK15. You
could short out internally exposed circuits and cause personal injury or equipment damage.
Reference Note:
Refer to the
System Setup and Power Options chapter of the WaveBook User’s Manual for
detailed information regarding the power aspects of WaveBook systems.
Using Fastener Panels to Stack Modules
For convenient mounting, the WBK15 has the same footprint as other WBK modules and WaveBooks.
Fastener panels (splice plates) provide a means for stacking WaveBooks and modules. Screw-on handles
are available for portable applications.
Reference Note:
For an illustration pertaining to mounting modules with fastener panels refer to the introduction
of this manual.
When using WBK17 modules in conjunction with other WBK modules, the WBK17
modules must be located closest to the WaveBook/516 (or /516A), due to the CA-217
cable length. The order of the other WBK modules does not matter.