Measurement Computing WBK Options - Manual (Page 159)

4. Test the system connections.
Before testing the system, make sure the device has been properly installed and powered-on. Make sure all
cables are properly and securely connected.
If the unit does not respond within 30 seconds perform the following steps:
1) reboot the system
2) upon power-up, re-open the Daq* Configuration applet
3) select another configuration setting
4) reinitiate the test
How to run the TCP/IP Test (The TCP/IP test is for Ethernet devices only)
The TCP/IP (Transmission Control Protocol/Internet Protocol) test is for Ethernet devices only. The test is
accessed and initiated as follows.
a. Open the Control Panel by navigating from the Windows’ Desktop as follows:
Start Menu ⇒ Settings ⇒ Control Panel
b. From the Control Panel, double-click the Daq* Configuration icon.
c. Select the device that you want to test from the Device Inventory configuration tree.
d. Click the <Properties> button. The Properties dialog box will open.
e. Click the “Test Hardware” tab.
f. Click the <TCP/IP Test> button.
Results of a TCP/IP Test
WBK25, pg. 14 919896 WBK25 Ethernet Interface Module User’s Guide