Measurement Computing WBK Options - Manual (Page 156)

DaqIPConfig
3. Select the device that is to have the address change.
Note: In the above figure there is only one device to select, i.e., WBK25.
4. Set the internet protocol (TCP/IP) settings to be compatible with host computer.
a. Select the radio button labeled “Use the following IP address.”
b. Enter the new internet protocol settings. If needed, consult your network administrator for
acceptable numbers.
c. Click the <OK> button.
5. Reboot the device.
The new IP address will not take affect until the device has been powered-off, then powered back on.
6. Repeat steps 3, 4, and 5 for other devices in the system.
After configuring the network settings for all devices, proceed to Step 7.
WBK25 Ethernet Interface Module User’s Guide 919896 WBK25, pg. 11