Installation requirements, Placement of system components – Hypertherm THC ArcGlide User Manual

Page 54

ArcGlide THC Instruction Manual 806450

2 – Installation

Installation requirements

All installation and service of the electrical system must conform to national and local electrical codes. This work should
be performed only by qualified, licensed personnel.

Direct any technical questions to the nearest Hypertherm Technical Service office listed in the front of this manual, or to
your table manufacturer.

Placement of system components

Place all system components in position prior to making electrical and interface connections.

Ground all system components to earth. See

information.

This manual is related to the following products:

EDGE Pro Ti Shape Cutting Control Rev.2 EDGE Pro Picopath Shape Cutting Control Rev.3 EDGE Pro HyPath Shape Cutting Control Rev.4 EDGE Pro SERCOS II Shape Cutting Control Rev.4 EDGE Pro SERCOS III Shape Cutting Control Rev.4