Hypertherm THC ArcGlide - Manual (Page 266)

266 ArcGlide THC Instruction Manual 806450
A – ArcGlide THC Serial Communication Protocol
ArcGlide THC to Command THC error conversions
The ArcGlide THC supports a broad error message set. When you are using the ArcGlide THC as a replacement for the
Command THC, ArcGlide error codes are converted into Command THC error codes, and only the Command THC error
codes are returned with the EC command.
 When you are using the ArcGlide THC in a new installation and using the ArcGlide extended command set:
 ArcGlide errors can be returned using the AE command.
 The actual ArcGlide errors will always be displayed on the ArcGlide control module and HMI displays.
 These errors are for reference. See ArcGlide errors on page 191 for a definition of each error and suggestions
for corrective action.
Table 9 – ArcGlide errors and equivalent Command THC errors
ArcGlide Command THC
Error Code Error Message Error Code Description
0 NO ERRORS 16 ERR-NO ERROR
1 ERR 1 FLASH SETUPS 2 ERR-EEPROM checksum Error
2 ERR 2 MAX SPEED EXCEEDED 4 ERR-Motion FAIL
3 ERR 3 LIFTER HOME TIMEOUT 4 ERR-Motion FAIL
4 ERR 4 PLATE CONTACT AT HOME 7 ERR-Nozzle Contact at Home
5 ERR 5 HOME LIM DURING OPR 1 ERR-Torch is in HOME LIMIT
6 ERR 6 LOWER LIM DURING OPR 0 ERR-Torch is in LOWER LIMIT
7 ERR 7 FAILED MOVE TO CROSSOVER 4 ERR-Motion FAIL
8 ERR 8 FAILED TO CONTACT PLATE 4 ERR-Motion FAIL
9 ERR 9 FAILED TO CLEAR PLATE 4 ERR-Motion FAIL
10 ERR 10 FAILED MOVE TO XFER HT 4 ERR-Motion FAIL
11 ERR 11 IHS SYNC TIMEOUT 5 ERR-Watchdog timeout FAIL
12 ERR 12 TRANSFER TIMEOUT 5 ERR-Watchdog timeout FAIL
13 ERR 13 LOST TRANSFER 11 ERR-Plasma Cable Missing
14 ERR 14 FAILED MOVE TO PIERCE 4 ERR-Motion FAIL
15 ERR 15 FAILED MOVE CUTHEIGHT 4 ERR-Motion FAIL
16 ERR 16 RAMPDOWN TIMEOUT 5 ERR-Watchdog timeout FAIL