Gasboy CFN Site Controller - Manual (Page 26)

18 Insight Interface - CFN3 only Pump Interface Manual v1.3
Gasboy CFN Series 03/20/03
Animation sequences
~C = insert card ~W = car wash
~R = receipt printing ~$ = cash
~N = remove nozzle ~B = spinning clock
~n = replace nozzle ~l = lift lever
~L = remove nozzle and lift lever
SDI applications
For SDI applications, there is one ‘insight.axx’ for each SDI where xx is the SDI address. For an
NT application, all Insights are controlled by one virtual SDI, which uses ‘insight.a01’.
The Insight program only reads this file when it starts, so you must restart the program,
using ALT-R, whenever a change is made. The same is true for broadcast messages and
receipt headings loaded in the site.
NOTE: Each SDI must have unique .A0# and .B0# files in the XBIN directory. For example, if
the site has one (1) Insight with an insight.A01 parameter file and another SDI for a Unitec car
wash, the car wash parameter file should be named WASH.A02 with a corresponding WASH.B02
binary file. These are all located in C:SC3\XBIN\.
The insight.axx file contains the following parameters. These are sample settings and the
information after ‘=’ may vary between systems. At the end of this manual is an example.
FIRST_ADDRESS= and LAST_ADDRESS= refer to the Insight address range this SDI is
supposed to control.
ID=Insights1-16
FIRST_ADDRESS=1
LAST_ADDRESS=16
The following setting determines if the Insight is to run in debit mode (TED or DEBIT module).
If the line is missing, the Insight assumes non-debit mode (DEBIT_MODE=N).
DEBIT_MODE=Y
or
DEBIT_MODE=N
The PROMPT= lines refer to the DES prompts loaded in the DEBIT module. These are
referenced by prompt number in the DEBIT module and they are listed here in order starting with
prompt #1. Load according to your particular DEBIT module.
If you get an error message saying “Debit prompt error” you are using a message that is not
listed. Make sure that all your prompts are listed with a PROMPT= line and match the site
controller prompts.
The following are the defaults. Everything after the “PROMPT=” is the wording of the
prompt, multiple spaces and punctuation are ignored.
PROMPT= enter amount $
PROMPT= enter driver id:
PROMPT= enter odometer:
PROMPT= enter PIN number:
PROMPT= enter vehicle number: