Gasboy CFN Site Controller - Manual (Page 12)

4 Tokheim Pump Interface Manual v1.3
Gasboy CFN Series 03/20/03
The options in the above table are:
1 — Pump is a multi-product dispenser.
2 — Pump always needs switch detect (off-hook) to activate.
3 — Pump has a cash-credit select button. (Customer can choose cash or credit payment
at the pump.)
4 — Site Controller can activate the pump without knowing the price or hose (for some
MPDs).
5 — Site Controller cannot choose the hose number or price (for some MPDs).
6 — Site Controller cannot get the dollar amount or volume during pumping.
7 — Pump can’t do switch detect or pulser timeouts (timeouts must be done by the
driver).
8 — Pump is a Tokheim stand-alone dispenser or Gasboy ® SPD 4.3 +/PAC 4.2+.
9 — Pump can only be activated from downloaded prices (the displayed prices are
downloaded).
10 — Pump never needs switch detect to activate (can be activated while it is still on-
hook).
11 — The PCU is slow to respond to requests (improves performance on pumps that are
inherently slow to respond or at sites that have a large number of pumps and are
very busy).
12 — The pump is a blender. (The Site Controller may not be able to keep component
product tank inventories for types of blender pumps that are not specifically
supported by Gasboy.) Do not use this option for Gilbarco and Tokheim Blenders
except for 5 product. The 5 product blender requires the 12 option (check that mode
26 is set to 1).
13 — The pump is a TCS configured to always download prices. (This allows TCS pumps
to display the correct price level for a sale, provided that the pump’s Tokheim
firmware supports the Mode 25 feature.)
14 — Pump is a Gasboy PAC.
15 — Single-sided pump (used for PCU auto-configuration).
16 — Tokheim Premier model.
17 — Requires start button (not required for Tokheim).
18 — Beeps without pressing payment on DPT or CRIND.
19 — Grade-select buttons exist.
20 — Beeps when offhook without START key being pressed.
21 — Pump has a lift-lever.
22 — Master Chain Pump.
23 — Wayne 3 product blender, hoses 1,3 and 5. For Wayne products V580 and V590U
only. Previously these pumps required using 5 hoses, setting the price code for
hoses 2 & 4 to 99. With this option, define 3 hoses only and the Wayne driver maps
them to the appropriate pump positions automatically.
*TCS 1 hose, multigrade non blend $/Cr 1,2,3,7,8,9,13,19
*Premier 1 hose, multigrade 1,2,7,8,9,13,16,19
*Premier 1 hose, multigrade $/Cr 1,2,3,7,8,9,13,16,19
Tokheim type Options to set