2 tokheim, Scii/cfn3 configurations, Tokheim pump driver – Gasboy CFN Site Controller User Manual

Page 10: Table.bin, Reader.bin, Tokheim

Tokheim

Pump Interface Manual v1.3

Gasboy CFN Series

03/20/03

Tokheim

SCII/CFN3 Configurations

The SCII must have version 1.0 or above operating system installed for all but Premier Disp. If
you are upgrading the site to 2.0 and a memory add-on module is not present on the SCII CPU
PCB, the hardware will also have to be upgraded. Order kit part number C07083.

If the Tokheim Premier/TCS dispensers are blenders and do not have grade select buttons,

then the Site Controller will need V2.0B or above software to work correctly. All CFN3 versions
will work with these dispensers.

Tokheim Pump Driver

In SCII software version 1.0J and below, the Tokheim pump driver was not optional, it was
incorporated into the software. In software version 1.0K and above, the software has to have the
driver set to Tokheim if the site is using the Tokheim family of pumps. All CFN3s must have this
pump driver. Use the STATUS command to determine if the driver is included.

TABLE.BIN

In the

TABLE.BIN

program in the SCII and CFN3, parameter #6 (Readers) should be set to the

total amount of readers at the site. This includes DPT and/or Insight readers, island readers and
console receipt printers.

READER.BIN

Submenus 1 and 3 in the

READER.BIN

program in the SCII/CFN3 must be set up correctly for

DPT’s.

For SCII, submenu 1 must be set up as follows:

Do not delete the following step-types: Step-type 1

ENTER CARD

, Step-type 2

SELECT PUMP

, Step-type 8

PLEASE WAIT

, Step-type 9

ACTIVATE PUMP

Step-type 2 must be before Step-type 8 in the reader program.

Step-type 11, REMOVE CARD is not used with a DPT/Insight.

For CFN3, submenu 1 must be set up as follows: