Comtech EF Data HPCST-5000 - Manual (Page 109)

High-Power TWTA Satellite Terminals Redundant System Installation
Rev. 1 3–25
3.4.1.1 Cabinet Slide Assembly
As shown in Figure 3-5, the controller is equipped with a pair of chassis slides. These
slides mate with a pair of slide assemblies mounted in a standard 19” (48.26 cm)rack.
The chassis slide assemblies are mounted to the cabinet with adjustable mounting
brackets (Figure 3-6).
Notes:
1. The specific installation details are dependent upon the rack (cabinet) design and
the specifics of the redundant system. Two cabinet slide assemblies and four
mounting brackets (two front and two back) are supplied with each controller.
2. If the front support bracket is mounted on the face of the cabinet mounting rail,
the combination of the bracket and the bracket mounting screw will not allow the
drawer front panel to be flush with the cabinet mounting rail. Spacers are used in
some systems to compensate for the thickness of the bracket and its mounting
screws.