Basler Electric DECS-400 - Manual (Page 209)

9369700990 Rev R 197
Below 10 Hz
Indication of a below 10 Hz protection alarm.
EDM Open
Indication of an open exciter diode protection alarm.
EDM Short
Indication of a shorted exciter diode protection alarm.
Volts per Hz
Indication of Volts per Hz protection alarm.
Over Excitation Limit
Indication that the overexcitation limiter is active.
Under Excitation Limit
Indication that the underexcitation limiter is active.
Under Freq Limit
Indication that the underfrequency limiter is active.
Volts per Hz Limit
Indication that the volts per hertz limiter is active.
Stator Current Limit
Indication that the stator current limiter is active.
Setpoint Low Limit
Indication that the active setpoint is at its lower limit.
Setpoint High Limit
Indication that the active setpoint is at its high limit.
Loss of Field Isolation Transducer
Indication of an FIT alarm.
Power Supply Low
Indication of a power supply low alarm.
Loss of IRIG
Indication of a loss of IRIG time signal alarm.
Modem Disconnect
Indication that the modem has been disconnected.
PSS Test On
Indication that the power system stabilizer test signal is active.
PSS Active
Indication that the power system stabilizer is active.
Volt Unbalance
Indication that the power system stabilizer is disabled by a volt unbalance condition.
DECS-400 Programmable Logic