Artesyn MVME2500 ECC Installation and Use (August 2014) - Manual (Page 58)

Controls, LEDs, and Connectors
MVME2500-ECC Installation and Use (6806800N30F) 58
3.4.2.4 JTAG Connector (P6)
The JTAG Connector can be used in conjunction with the JTAG board and ASSET hardware.
21 PMC IO 21 53 PMC IO 53
22 PMC IO 22 54 PMC IO 54
23 PMC IO 23 55 PMC IO 55
24 PMC IO 24 56 PMC IO 56
25 PMC IO 25 57 PMC IO 57
26 PMC IO 26 58 PMC IO 58
27 PMC IO 27 59 PMC IO 59
28 PMC IO 28 60 PMC IO 60
29 PMC IO 29 61 PMC IO 61
30 PMC IO 30 62 PMC IO 62
31 PMC IO 31 63 PMC IO 63
32 PMC IO 32 64 PMC IO 64
Table 3-13 PMC J14 Connector (continued)
Pin Signal Description Pin Signal Description
Table 3-14 JTAG Connector (P6)
Pin Signal Description Pin Signal Description
1 NC 2 +3.3V FROM +5V
3 SPI HOLD 0 4 SPI CS 0
5 SPI CLK 6 SPI CS 1
7 SPI HOLD 1 8 SPI MOSI
9 SPI MISO 10 GND
11 SPI VCC 12 SCAN 1 TCK
13 SCAN 1 TDI 14 GND
15 SCAN 1 TRST 16 SCAN 1 TDO
17 SCAN 1 TMS 18 +3.3V