Artesyn MVME2500 ECC Installation and Use (August 2014) - Manual (Page 37)

Hardware Preparation and Installation
MVME2500-ECC Installation and Use (6806800N30F) 37
1. Attach an ESD strap to your wrist. Attach the other end of the strap to the chassis as a
ground. Make sure that it is securely fastened throughout the procedure.
2. Remove the PMC/XMC filler plate from the front panel cut-out.
3. Slide the front bezel of the PMC/XMC into the cut-out from behind. The front bezel of the
PMC/XMC module will be flushed with the board when the connectors on the module align
with the mating connectors on the board.
4. Align the mating connectors properly and apply minimal pressure to the PMC/XMC until it
is seated to the board.
5. Insert the four PMC/XMC mounting screws through the mounting holes on the bottom side
of the board, and then thread the four mount points on the PMC/XMC. Tighten the screws.
6. Install the board into the appropriate card slot. Make sure that the board is well seated into
the backplane connectors. Do not damage or bend connector pins.
7. Replace the chassis or system cover.
8. Reconnect the system to the power source and then turn on the system.
2.6 Installing and Removing the Board
This section describes the recommended procedure for installing the board in a chassis. Read
all warnings and instructions before installing the board.
The MVME2500-ECC does not support hot swap. Power off the slot or system and make sure
that the serial ports and switches are properly configured.
When removing the PMC/XMC, hold it by its long side and exert minimal force when pulling
it from the baseboad to prevent pin damage.