Artesyn MVME2500 ECC Installation and Use (August 2014) - Manual (Page 33)

Hardware Preparation and Installation
MVME2500-ECC Installation and Use (6806800N30F) 33
The following table provides an estimate of the typical and maximum power required.
The following table shows the power available when the MVME2500-ECC is installed in either a
three row or five row chassis and when PMCs are present.
Table 2-2 Power Requirements
Board Variant Maximum (Calculated) Typical (Measured Operating)
MVME2500-01080101E 18.5 W 14.8 W
MVME2500-01080101S 18.5 W 14.8 W
MVME2500-02120201E 24 W 16.6 W
MVME2500-02120201S 24 W 16.6 W
MVME2500-02100202E 24 W 16.6 W
MVME2500-02100202S 24 W 16.6 W
The power is measured when the board is in standby (Linux prompt). Power will significantly
increase when adding hard drives or a XMC/PMC card.
Chassis Type Available Power Power With PMCs
Three Row 70 W maximum below 70 W
Five Row 90 W maximum below 90 W
Keep below power limit. Cooling limitations must be considered.