Artesyn MVME2500 ECC Installation and Use (August 2014) - Manual (Page 133)

Replacing the Battery
MVME2500-ECC Installation and Use (6806800N30F) 133
The battery provides seven years of data retention, summing up all periods of actual data use.
Artesyn Embedded Technologies therefore assumes that there is usually no need to replace the
battery except, for example, in case of long-term spare part handling.
Board/System Damage
 Incorrect replacement of lithium batteries can result in a hazardous explosion.
 When replacing the on-board lithium battery, make sure that the new and the old
battery are exactly the same battery models.
 If the respective battery model is not available, contact your local Artesyn sales
representative for the availability of alternative, officially approved battery models.
Data Loss
 Replacing the battery can result in loss of time settings. Backup power prevents the loss
of data during replacement.
 Quickly replacing the battery may save time settings.
Data Loss
 If the battery has low or insufficient power the RTC is initialized.
 Replace the battery before seven years of actual battery use have elapsed.
PCB and Battery Holder Damage
 Removing the battery with a screw driver may damage the PCB or the battery holder. To
prevent damage, do not use a screw driver to remove the battery from its holder.