Artesyn MVME2500 ECC Installation and Use (August 2014) - Manual (Page 101)

Memory Maps and Registers
MVME2500-ECC Installation and Use (6806800N30F) 101
5.4.15 Reset Control and Reset Reason Register
The MVME2500-ECC provides an 8-bit register to execute the shutdown and reset commands.
The board's reset reason is also included in this register.
Note: Changing a Reserved Register setting may cause damage to the board damage or
malfunction. Reserved register settings should not be changed.
Table 5-17 PLD Shutdown and Reset Control and Reset Reason Register
REG PLD Shutdown and Reset Reason- 0xFFDF00FF
Bit 7 6 5 4 3 2 1 0
Field AUTO_SH
DN_MASK Shutdown Soft_RST Clear_Cause CPU_RESET WD_TIME
OUT LRSTO Sft_RST
OPER R/W W W W R
RESET 0 0 0 0 X X X X
Field Description
AUTO_SHDN_MASK Automatic Shutdown Mask
1 - Auto Shutdown Mask Enable
0 - Auto Shutdown Mask Disable
Note: Automatic shutdown is generated after 1 second whenever a power good signal de-
asserts.
Shutdown Board Shutdown Register
1 - Shutdown Enable
0 - Shutdown Disable
Note: If a board entered the shutdown state (by writing a '1' in this register), the chassis'
power needs to be cycled to power up the board again.
Soft_RST Board Soft Reset (self clearing)
1 - Execute soft reset
0 - No reset