Artesyn MVME2500 ECC Installation and Use (August 2014) - Manual (Page 32)

Hardware Preparation and Installation
MVME2500-ECC Installation and Use (6806800N30F) 32
2.3.2 Power Requirements
The board uses +5.0 V from the VMEbus backplane. On board power supply generates the
required voltages for the various ICs. The MVME2500-ECC connects the +12 V and -12 V
supplies from the backplane to the PMC sites, while the +3.3 V power supplied to the PMC sites
comes from the +5.0 V backplane power. A maximum of 10 A of +3.3 V power is available to
the PMC sites, however the 90 W +5.0 V limit must be observed as well as any cooling
limitations.
Product Damage
 High humidity and condensation on the board surface causes short circuits.
 Do not operate the board outside the specified environmental limits.
 Make sure the board is completely dry and there is no moisture on any surface before
applying power.