Artesyn MVME2500 ECC Installation and Use (August 2014) - Manual (Page 114)

Boot System
MVME2500-ECC Installation and Use (6806800N30F) 114
6.5 MVME2500-ECC Specific U-Boot Commands
Table 6-1 MVME2500-ECC Specific U-Boot Commands
Command Description
base Print or set address offset
bdinfo Print board info structure
boot Boot default, i.e., run 'bootcmd'
bootd Boot default, i.e., run 'bootcmd'
bootelf Boot from an ELF image in memory
bootm Boot application image from memory
bootp Boot image through network using BOOTP/TFTP protocol
bootvx Boot VxWorks from an ELF image
cmp Memory compare
coninfo Print console devices and information
cp Memory copy
cpu Multiprocessor CPU boot manipulation and release
crc32 Checksum calculation
date Get/set/reset date & time
diags Runs POST diags
echo Echo args to console
exit Exit script
ext2load Load binary file from a Ext2 file system
ext2ls List files in a directory (default /)
fatinfo Print information about file system
fatload Load binary file from a DOS file system
fatls List files in a directory (default /)
fdt Flattened device tree utility commands
go Start application at address 'addr'