beautypg.com

AMETEK Compact i/iX Series User Manual

Page 73

background image

User Manual

Compact i/iX Series

AMETEK Programmable Power

California Instruments

73

ENTRY

DESCRIPTION

power indicating it is in Auxiliary mode. You
can press any key to get in the menus but no
control is possible.

LANGUAGE

SCPI
ABLE

Displays the active programming command
language syntax selection. Default for
compact i/iX series is SCPI (Standard
commands for Programamble Instruments). If
the

–ABL option is installed, the ABLE (Atlas

Based Language Extension) syntax can be
selected. See programming manual for details
on use either syntax.

SYSTEM

1501iX

This field is not user controlled. It merely
indicates the configuration of the power
system.
If the multi-box option (-MB) is installed, this
field can be changed between 750, 1500 or
3000. Set this field to the correct power level
for the configured system using the shuttle:
Unit(s)

Setting

751i/iX

751i / 751iX

1501i/iX

1501i / 1501iX

2 x 751i/iX

1501i / 1501iX

2 x 1501i/iX

3001i / 3001iX

To reconfigure an existing system on which
the MB option was not configured, contact
AMETEK Programmable Power customer
support (

[email protected]

).

LANetwork

LAN

If the

–LAN option is installed; pressing Enter

while the cursor is on the LANetwork entry
provides access to the LAN interface setting
screens listed below.

Note: These screens require firmware 0.25 or higher. To
update older firmware revisions, contact AMETEK
Programmable Power customer support
(

[email protected]

) or check CI website.

IP Address

Displays the IP address setting. This value can
be changed by pressing the SET key and
entering a new value from the keypad. Use the
numeric data pad to enter each field. To move
between the four fields, use the decimal point
key on the keypad.
To set a fixed IP address, press SET and
enter the desired IP address. To set the unit to
DHCP mode, press SET and enter all zeros
(0.0.0.0) as the IP address and cycle power
two times. The obtained IP address will be
displayed after the second power on. For the
DHCP setting to work however, the unit MUST
be connected to a network with a DHCP
server.
Any change to this value will NOT take effect