AMETEK Compact i/iX Series - Manual (Page 41)

User Manual Compact i/iX Series
AMETEK Programmable Power California Instruments 41
3.7.4 BNC Connectors (-LKM / -LKS options) – J28/J29
BNC connectors. Functions are called out on rear panel decal. Table 3-6 shows connections for the
optional -LKM and -LKS clock and lock mode. This option is available on iX models. Refer to section
3.10 for more details.
BNC Ref. Description
CLOCK J28 Clock Option (TTL output on Master / TTL input on Auxiliary)
LOCK J29 Lock Option (TTL output on Master / TTL input on Auxiliary)
Table 3-6: BNC Connectors
3.7.5 System Interface Connectors – MASTER (J30) and AUXILIARY (J31)
WARNING: The system interface connectors are for use with AMETEK Programmable
Power supplied cables, and only between California Instruments equipment.
A set of two System Interface connectors is located on the rear panel of each iX Series chassis. The
system interface is used to connect two power sources in a Master/Auxiliary configuration to create a
1501iX/2, 1501i/2, 3001iX/2 or 3001i/2 AC power source configuration. A suitable System Interface
cable MUST be used to connect both chassis as shown in Figure 3-7.
Note that no user accessible signals are provided on the System Interface connections and they
should only be used for their intended purpose.