AMETEK Compact i/iX Series - Manual (Page 28)

User Manual Compact i/iX Series
AMETEK Programmable Power California Instruments 28
2.7 Available Options – i Series
Interface Options
-GPIB GPIB Remote control interface. This option is not field installable and
must be specified at the time of original unit order.
Misc. Options
-ABL Atlas Based Language Extension. The ABLE command language
provides bus compatability with 9012 PIP controllers.
-EXS External sync input. This option is not field installable and must be
specified at the time of original unit order. This option is mutually
exclusive with the
–LKS and -RPF option.
-RMS Rack mount slides. Available for Series II models only.
-RPV Remote programming voltage. DC voltage input 0 to 10 VDC for 0 to full-
scale output voltage programming.
-RPF Remote programming frequency. DC voltage input 0 to 10 VDC for 0 to
800 Hz output frequency programming. Input impedance is 20 Kohm.
This option is mutually exclusive with the
–LKS and -EXS option.
-WHM Watt-hour measurement option.
2.8 Available Options
– iX Series
Interface Options
-LAN Ethernet LAN interface connection. RJ45 connector. This option is not
field installable and must be specified at the time of original unit order.
Test Options
-160 RTCA/DO-160 Revision D and E, EuroCAE test firmware. Revision E
requires use of iXCGui software (included).
-704 Mil-Std 704 Revision D and E test firmware.
-704F Mil-Std 704 Revisions A through F test firmware.
-ABD Airbus ABD0100.1.8 test software. Requires use of iXCGui software
(included).
-AMD Airbus A400M Directive AMD24 test software. Requires use of iXCGui
software (included).
-B787 Boeing B787-0147 test software. Requires use of iXCGui software
(included).
Misc. Options
-ABL Atlas Based Language Extension. The ABLE command language
provides bus compatability with 9012 PIP controllers.
-EXS External sync input. This option is not field installable and must be
specified at the time of original unit order. This option is mutually
exclusive with the
–LKS and -RPF option.
-LKM Clock and Lock Master. Enables synchronizing outputs of two iX AC
sources. This mode supports a frequency range of 16 to 819 Hz.
The
–LKM applies to the master unit. This option is not field installable
and must be specified at the time of original unit order.
-LKS Clock and Lock Auxiliary. See -LKM for details. The –LKS applies to the