AMETEK Compact i/iX Series - Manual (Page 104)

User Manual Compact i/iX Series
AMETEK Programmable Power California Instruments 104
7.6 Amplifier Module Data
This section lists the various connectors and interface pin outs to the 6005-400-1 amplifier module.
7.6.1 CONTROL BOARD
7.6.1.1 J1 - LV POWER
PINS NAME DESCRIPTION
1,2,3 +24V_FAN +12.0 Vdc to +24.0 Vdc @ 200 mAdc for module fan. Voltage is
externally controlled according to output current.
4,5,6 FAN_COM Return for +24V_FAN
7,8 +15G +15 Vdc +/- 0.5Vdc @ 450 mAdc for gate drive
9,10 G_COM Return for +15G
11,12 +15LV +15 Vdc +/- 0.5Vdc @ 150 mAdc for control circuits
13,14 LV_COM Return for +15LV and –15LV
15,16 -15_LV -15Vdc +/-0.5Vdc @ 100 mAdc for control circuits
7.6.1.2 J5 - FAN
PINS NAME DESCRIPTION
1 FAN_COM Return for fan
2 +24V_FAN DC voltage for fan
7.6.1.3 J6 - E/A IN/OUT
PINS NAME DESCRIPTION
1 E/A COM Return for E/A IN/OUT
2 E/A IN/OUT Error amplifier signal from master module to parallel auxiliary
modules
7.6.1.4 J2 - CONTROL SIGNALS
PINS NAME DESCRIPTION
1 A_COM Analog common
2 A_SIG_HI Phase A oscillator signal, 16 Hz to 1 kHz, 0 – 5.3 Vac
3 B_SIG_HI Phase B oscillator signal, values same as A_SIG_HI
4 C_SIG_HI Phase C oscillator signal, values same as A_SIG_HI
5 SCOM Signal common for A/B/C_SIG_HI
6 DCOM Digital logic common
7 LO_RNG Low Range control signal, input to module, TTL LO = Low Voltage
Range, TTL HI = High Voltage Range
8 /AMP_FLT Amplifier fault indicator signal, output from module, open collector,
LO = blown fuse fault detected, HI = normal
9 SUM Not used
10 /OVT Overtemperature fault indicator signal, output from module, open
collector, LO = Over temp fault detected, HI = normal