AMETEK Compact i/iX Series - Manual (Page 33)

User Manual Compact i/iX Series
AMETEK Programmable Power California Instruments 33
3.3.2 Rackmount
Series II
For Series II units, rack slide mounting holes are provided along the side of the unit. Note that only
correct length screws should be used to mount rack slides.
CAUTION: Do not attached rack slides using screws that are longer than TBD as some of
the mounting holes do not have blind studs and internal damage may be caused by longer
screws.
If the power source is to be mounted in cabinet system, proper supports such as rack slides, L-
brackets or a shelf must be provided to support the weight of the unit along its depth. The rack ears on
the front of the power source are not intended to support the entire weight of the unit and should only
be used to prevent the unit from sliding forward.
Contact the cabinet manufacturer for suitable rack support accessories.
3.3.3 Multi chassis
Multi chassis configurations consist of two self-contained iX Series power sources. They must be
connected through the system interface using the supplied cable. Output wiring from each chassis to
the EUT must be of equal wire gage and length to ensure proper current sharing between units.