AMETEK Compact i/iX Series - Manual (Page 43)

User Manual Compact i/iX Series
AMETEK Programmable Power California Instruments 43
Pin # Signal
Names Signal Description Pin # Signal
Names Signal Description
12 Shield Chassis Ground 24 Single
GND Signal Ground.
Table 3-8: GPIB Interface Connector pin out.
3.7.8 LAN Interface – RJ45 – J35
An optional RJ45 Ethernet 10BaseT connector is located on the rear panel for remote control. A
standard RJ45 UTP patch cord between the AC Source and a network Hub may be used to connect
the AC source to a LAN. For direct connection to a PC LAN card, a crossover RJ45 cable is required.
Consult your network administrator for directions on connecting the AC source to any corporate LAN.
If the –LAN Ethernet interface option is present, the MAC Address (Media Access Control) of the
Ethernet port is printed on the serial tag of the power source. The serial tag is located on the rear panel
of the unit.
For information on how to set up a network connection or a direct PC connection using the LAN
interface, refer to the i/iX Series Programming Manual P/N 6005-961 distributed in Adobe PDF format
on CD ROM CIC496.
LAN
Pin Ethernet TPE
10BaseT/100BastT/1000BaseT EIA/TIA 568A EIA/TIA 568B
Crossover
1 Transmit/Receive Data 0 + White with green stripe White with orange stripe
2 Transmit/Receive Data 0 - Green with white stripe or
solid green Orange with white stripe or
solid orange
3 Transmit/Receive Data 1 + White with orange stripe White with green stripe
4 Transmit/Receive Data 2 + Blue with white stripe or
solid blue Blue with white stripe or
solid blue
5 Transmit/Receive Data 2 - White with blue stripe White with blue stripe
6 Transmit/Receive Data 1 - Orange with white stripe
or solid orange Green with white stripe or
solid
7 Transmit/Receive Data 3 + White with brown stripe or
solid brown White with brown stripe or
solid brown
8 Transmit/Receive Data 3 - Brown with white stripe or
solid brown. Brown with white stripe or
solid brown
Table 3-9: RJ45 LAN Connector pin out.