Altera CPRI v6.0 MegaCore Function - Manual (Page 94)

Bits Field Name Type Value on
Reset
Description
2
tx_
enable_
force
RW 1'b0 Specifies whether the RE slave self-synchronization testing
feature is activated. If the feature is activated, the CPRI RE slave
attempts to achieve link synchronization without a CPRI link
connection to a CPRI master.
Set this field to the value of 1 to enable the feature. The value of
1 is only valid if the CPRI IP core is configured as a CPRI slave.
1
operation
_mode
RW #nik141
1442180
153/fn_
param_
ed_det
Specifies whether the CPRI v6.0 IP core is configured as a CPRI
slave or a CPRI master, according to the following values:
• 1'b0: The IP core is configured as a CPRI master.
• 1'b1: The IP core is configured as a CPRI slave.
0
tx_enable
RW 1'b0 Enable transmission on CPRI link.
Related Information
• Writing the Hyperframe Control Words on page 3-39
• CPRI v6.0 IP Core Self-Synchronization Feature on page 3-50
BIT_RATE_CONFIG Register
Table 5-6: CPRI v6.0 IP Core BIT_RATE_CONFIG Register at Offset 0x0C
Bits Field Name Type Value on
Reset
Description
31:5 Reserved UR0 27'b0
(3) Reset value is the value you specify for Operaton mode in the CPRI v6.0 parameter editor.
UG-01156
2015.02.16
BIT_RATE_CONFIG Register 5-5
CPRI v6.0 IP Core Registers Altera Corporation
Send Feedback