Blinking a drive led – StorCase Technology Fibre-to-SCSI Single RAID User Manual

Page 130

118

Configuration

StorCase Technology, Inc.

S10C100 User's Guide - Rev. A01

Select the desired option and press Enter.

Reboot or rescan to make any changes take effect (refer to sections "Rebooting the

Controller" and/or "Rescanning All Channels" for further information).

Blinking a Drive LED

This function allows the user to blink the LED on a specific drive. The drive continues blinking

its LED until the user does one of the following:

Press Esc before the Disk Array Administrator Utility times out.
Repeat the blink LED command.

To blink a drive LED:

Select Utilities Menu from the System Menu and press Enter.
The Utilities Menu should now display (Figure 47).

Select Drive Utilities Menu and press Enter.
The Drive Utilities Menu should now display (Figure 76).

Select Blink Drive LED and press Enter.
The Select Drive screen should now display.

Select the desired drive and press Enter.

Press Esc to stop blinking the LED.