ADLINK ND-6067 - Manual (Page 231)

229
6.8.1 Read Command Leading Code Setting
@Description
Read command leading code setting and host watchdog status.
@Syntax
~(Addr)0
~ Command leading code.
(Addr) Address ID
0 Read command leading code setting.
@Response
!(Addr)(Status)(C1)(C2)(C3)(C4)(C5)(C6)
or
?(Addr)
! Command is valid.
? Command is invalid.
(Addr) Address ID
(Status) (2-character)
Bit 0 : Reserved
Bit 1 : Power failure or watchdog failure
Bit 2 : Host watchdog is enable
Bit 3 : Host failure
(C1) Leading code 1, for read configuration status,
firmware version, etc. default is $. (1-character)
(C2) Leading code 2, for read synchronize sampling, digital
output ,default is #. (1-character)
(C3) Leading code 3, for change configuration.
default is %. (1-character)
(C4) Leading code 4, for read alarm status, enable alarm,
etc. default is @. (1-character)
(C5) Leading code 5, for read command leading code,
change command leading code, etc. default is ~.
(1-character)
(C6) Leading code 6, this leading code is reserved. default
is *. (1-character)
@Example
User command: ~060
Response: !0600$#%@~*
Command leading code setting is $#%@~* for module address ID is
06, current status is factory default setting.
(601x,602x,605x,
606x,6080,6531)