ADLINK PCM-6308V+ - Manual

Appendix for PC/104plus modules
Manual Rev. 1.00: March 28, 2002 Part No : 50-40033-200
1 Introduction
1.1 Introduction of PC/104 plus
PC/104 plus is a special bus architecture designed for embedded systems. A third connector
opposite the PC/104 connectors supports the PCI bus. Basically the electrical specifications of the
PC/104 plus bus are compliant with the PCI signals, except 64-bit extensions, JTAG, PRSNT or
CLKRUN signals. The mechanical specifications are changed to “module stack”, please refer to the
figure shown below. According to the specifications of PC/104 plus, PC/104 plus modules are
installed and configured by switching CLK, IDSEL, INT, REQ and GNT signals through multiplexers
to the appropriate connections.
.
Rotary switch on PCM-6308V+ is used for these signals switching, please refer to section 4 for
details in this appendix
1.2 Specifications for PCM-6308V+
The specifications of the PCM-6308V+ are exactly the same as the PCI-6308V. Please refer to
section 1.3 of the PCI-6308V manual for detailed information.
1.3 Software support
The software support is exactly the same as the PCI-6308V. Please refer to section 1.4 of the
PCI-6308V manual for detailed information.
PC104+ Module
PC104+ Module
PC104+ Host Board