Setting up motion detection – Interlogix DVR 60 User Manual User Manual
Page 95
11BChapter 12: Configuring alarm settings
TruVision DVR 60 User Manual
89
Figure 37: Notification types
Note
: To trigger the alarm indicator bar on the front panel to flash on and off
when motion is detected, see “Setting up system notifications” on page 95.
The notification types that you can select include:
• Full
Screen:
When an alarm is triggered, the local spot monitor (VGA or BNC
monitor) displays an image in live mode. This alarm can be configured under
the Popup Alarm Image rules method. For alarms that are triggered
simultaneously, images display one at a time every 10 seconds (default dwell
time). You can set a different dwell time using the Dwell Time setting in the
Display screen. When the alarm stops, cycling of the images stops and you
return to live mode.
• Buzzer:
Triggers an audible beep when a notification or alarm is detected.
• TCP/IP:
Sends a signal to TruVision Navigator or other software applications
when an alarm or notification is detected.
• Alarm
Out:
Trigger an alarm output when a notification is detected. An alarm
output can be configured by following the steps listed in “Setting up external
alarms” on page 92.
Notification:
Sends an e-mail when an alarm or notification is
detected. Sending an email can be configured by following the steps listed in
“Configuring e-mail settings” on page 103.
Setting up motion detection
Define the motion detection settings for each camera.