Interlogix DVR 60 User Manual - Manual (Page 104)

11BChapter 12: Configuring alarm settings
98 TruVision DVR 60 User Manual
To set up video tampering detection:
1. Enter Camera Management screen by selecting Camera in the main menu.
2. Select a camera for which you want to configure video loss detection, and
then click
Setup
.
3. Click the Advanced tab.
4. Check the Tamper Detection box to enable the feature.
5. Click Area Setup next to the Tamper Detection box to enter the tamper
detection area setup interface.
6. Define a tampering area.
The tamper detection area setup interface, shown in the figure below, lets you
to define areas where you in which you want camera tamper to be detected.
Click and drag an area to mark that area for video tampering. Marked areas
are outlined by a red outline. You can only set one tampering area with the
full screen being the maximum area.
7. Right-click the mouse, and then click Sensitivity to set the tamper detection
sensitivity. A higher value indicates higher sensitivity and vice versa.
8. Click
Exit
to return to the Camera Settings screen.
9. Click
Rules
next to the Tamper Detection box to enter the Rules screen.
10. Click the Notifications tab to define the method you want your DVR to notify
you of video tampering. See “Description of alarm notification types” on page
88 for more information. Click
OK .
11. Click the Schedule tab. Set the schedule of when you want video tampering
detection to be enabled. Schedule can be set for all week or any day of the
week with up to eight time periods per day.
12. Click the
Apply
button to finish.
13. Repeat steps 2 to 12 for other cameras.